Tacoma Roof Rack Setups: 6 Real-World Ways to Run a Slimsport on a 2nd or 3rd Gen

Six real-world ways Tacoma owners use a Front Runner Slimsport cab rack, with what to mount for each setup and what the low-profile rack isn't built for.


By Ryan Korpi
3 min read

Toyota Tacoma on a forest trail with a Front Runner Slimsport roof rack carrying gear

A cab rack only earns its spot if you use it. Here are six setups we see Tacoma owners run on the Front Runner Slimsport Roof Rack Kit for 2005–2023 Tacoma, with what to mount for each one and where the low-profile design has limits.

The baseline for all of them is a 55.9" x 47.1" flat deck with top and bottom T-slots that take standard 8 mm bolts and all Front Runner top-mount accessories. The rack adds about 2.4"–2.8" above your roof's highest point, and the included full fairing helps keep it quiet.

1. The recovery setup (boards + shovel)

Who it's for: Trail days and weekend wheeling. Recovery boards and a shovel come out of the bed and onto the roof, where you can reach them fast when you're stuck.

Mount: Top-mount board and shovel brackets from Front Runner roof rack accessories. Keep the load flat and low.

2. The daily driver with a cargo box

Who it's for: Commuters and family trips that need extra dry storage without giving up the bed.

Mount: A low-profile box on the T-slots. Measure your total height (truck + rack + box) before you take it into a garage.

3. The light bar build

Who it's for: Night trail runs and rural roads, used where legal.

Mount: Swap the standard fairing for the Tacoma Slimsport 40" Light Bar Wind Fairing, which has a 40" cutout. Full walkthrough: Tacoma Roof Rack with a Light Bar.

4. The paddle and bike hauler

Who it's for: Kayak, SUP, and bike owners who want the bed free for camp gear.

Mount: Top-mount carriers from Front Runner roof rack accessories. A flat deck makes loading and strapping easier than round crossbars.

5. The work rack

Who it's for: Contractors and DIYers carrying lumber, pipe, or ladders on a truck that's also the weekend rig.

Mount: Tie-downs in the T-slots, plus the Slimsport Side Mount Accessory Bracket / Small if you need side-mount gear. One owner review on Front Runner's site mentions strapping toolboxes on top, so this isn't a stretch.

6. The weekend camp kit

Who it's for: Bed-camping and ground-tent trips where the roof carries the bulky, light stuff: chairs, a table, firewood, a duffel.

Mount: A low box or bag strapped down, with a Handle/Light Slimsport Rack Bracket for a grab point or a camp light.

What the Slimsport isn't built for

Pick your setup, then the rack

Most Tacoma owners end up running two of these setups, usually recovery plus a light bar or a box. The Slimsport is built for that: low, quiet, and modular.

Start your build: Shop the Front Runner Slimsport Roof Rack Kit for 2005–2023 Tacoma (KSTT003T) — free-standing T-slot deck, full wind fairing included, no drilling.

See all Toyota kits in Front Runner Toyota Slimsport roof racks.

FAQ

What are the best roof rack accessories for a Tacoma?

For a low cab rack like the Slimsport, owners usually start with recovery board mounts, a shovel bracket, a cargo box, and a 40" light bar fairing. All Front Runner top-mount accessories fit the T-slots.

Can I mount side accessories on a Slimsport?

Yes, with the Slimsport Side Mount Accessory Bracket / Small. A few side-mount items, like the Hi-Lift jack bracket, aren't suited to the low-profile rails.

Need fitment help?

Email info@ventureoverlandcompany.com with your year, cab style, and trim (sunroof or not), plus what you plan to carry up top. We'll confirm the right kit and the accessories that fit it before you order.


Leave a comment

Please note, comments need to be approved before they are published.